| 1. | Evaluation of uncertainty of the indication relative error for a diaphragm gas meter
膜式煤气表基本误差检定的不确定度评定 |
| 2. | Relative error of closure
相对闭合差 |
| 3. | The turbidity experiments show that the relative error is not more than 3 % with this turbidity meter
通过实验分析，结果表明相对误差不大于3 % 。 |
| 4. | This method is especially accurate in damping identification with the relative error less than 1 % to theoretic values
尤其在阻尼比的识别上，相对误差在1 %以下。 |
| 5. | In comparison with the real value of flux , the relative error of the measured data by the method is within 5 %
用该法测得的流量值与实际流量相比较，相对误差在5 %以内。 |
| 6. | The n - alcohols were used to verify the accuracy of the method , and a relative error was found to be 2 . 2 %
用正构脂肪醇对定量分析方法进行了考察，其结果的相对标准误差为2 . 2 % 。 |
| 7. | The results show that the fitting average relative errors with the two models are respectively 12 . 9 % and 38 . 7 %
研究结果表明两者的拟合值与实验值相比较的平均相对误差分别为12 . 9 %和38 . 7 % 。 |
| 8. | The calibration result is in accord with the actual measurement , with a relative error low than 30 %
率定结果与实测数据吻合较好，相对误差多在30 %之内，一定程度上反映了太湖流域的水质概况。 |
| 9. | On - line results indicate that the predicted results are more accurate with a relative error within 3 %
应用结果表明，采用本方法预报轧制力时精度优于传统的数学模型，相对误差可以控制在3 %以内。 |
| 10. | It is found that the fitting accuracy is higher and the mean relative error between fitted and standard value is less than 0 . 3 %
该方法的拟合精度较高，拟合值与辐射模式标准值的平均相对误差在0 . 3 %以下。 |
